Log In. Thank you for helping keep Eng-Tips Forums free from inappropriate posts. The Eng-Tips staff will check this out and take appropriate action. Click Here to join Eng-Tips and talk with other members! Already a Member? Join your peers on the Internet's largest technical engineering professional community.
|Published (Last):||4 June 2008|
|PDF File Size:||8.85 Mb|
|ePub File Size:||4.57 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s - view previous versions of standard. More A This specification covers rail-steel and axle-steel deformed bars for concrete reinforcement. The standard sizes and dimensions of deformed bars and their number designation are presented.
The carbon determination, deformation requirements and deformation measurement are provided. The material shall conform to the requirements prescribed by the specification. The yield point or yield strength shall be determined by either drop of the beam or halt in the gage of the testing machine, or by extension under load using an autographic diagram method.
For all bar sizes a tension test, a bend test and a set of dimensional property tests including bar weight and spacing, height, and gap of deformations shall be made from each lot of 10 tons. This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The standard sizes and dimensions of deformed bars and their number designations are given in Table 1.
All sizes and grades of all types may not be readily available; manufacturers should be consulted to verify availability. These notes and footnotes, excluding those in tables and figures, shall not be considered as requirements of the specification. Type A is of two minimum yield levels, namely 40 psi [ MPa] and 60 psi [ MPa] designated as Grade 40  and Grade 60 , respectively.
Within the text, the SI units are shown in brackets. The values stated must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Scope 1. Link to Active This link will always route to the current Active version of the standard.
Active view current version of standard. Translated Standard: Spanish. Other Historical Standards. More A The standard sizes and dimensions of deformed bars and their number designations are given in Table 1. All sizes and grades of all types may not be readily available; manufacturers should be consulted to verify availability.
ASTM A996 Tension Rail Axle Steel Test Equipment
Historical View current edition. Prices subject to change without notice. About Us. Contact Us. Sign In. Standards Store. Purchase History.